Witura WT-9001 IP65 Instrukcja Użytkownika Pobierz pdf (Strona 12)

WT-9001 IP65 GSM Remote Control And Alarm System

WT-9001 IP65 – USER MANUAL – Rev. 3.4 – Technical Support: technical@witura.com

WT-9001

And then the WT-9001 will reply a message back to you that the administrator number

has been added.

Example of Returned Message:

TEL1=1111222233

Note: Programming the administrator numbers is necessary in order to operate all other

functions and to receive text alerts when the relays activated.

Note: It is advised that the owner should set the system to allow programming

access for administrators only after programming the Administrator numbers.

Sending SMS Command: *ANY?#1

Only the administrators in the list will have the access control to the system, any person

outside the list in this case will not have the authority to access the system and text

command sent to the system will be rejected.

To allow any person gain access to the system just send SMS Command: *ANY?#0

Note: Only Administrator number 1 and 2 may send this SMS command

The WT-9001 has 8 outputs that are connected to an on-board relay which can be

activated by sending an SMS command.

To activate any output relay, you can send a text command via SMS specifying the

output number and the number of seconds the output should stay on to the unit. It is

possible to set up to maximum of 65,535 seconds

Text Command:

5.2 Access Control For Administrator

5.3 OUTPUT Settings

5.3.1 Switch On the Output Relay For a Specific Time

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 30 31

Brak uwag

Witura WT-9001 IP65 Instrukcja Użytkownika Strona 12